#Schwintek slide out service manual install

WHEN THE MOTOR BRAKE IS DISENGAGED THE SLIDEOUT ROOM WILL NOT LOCK INTO PLACE THEREFORE, THE ROOM WILL NOT BE SEALED.

#Schwintek slide out service manual install

Install the transit bars to the slideout room (if so equipped) and take the unit to an authorized dealer for service. This will ensure the room is locked into a sealed position.ДЁ. When the room is fully in (or out) apply pressure to the wrench/ratchet and return the brake lever to its engaged position. NOTE: If the slideout system is supplied with a gearbox override (optional), use the crank handle to move the room.Д§. Using either a 5/8вЂќ or 3/4вЂќ wrench or socket, crank the room either in or out completely (depending on your needs). Locate the manual override for the slideout system.Д¦. This will release the brake that holds the room in place.ДҐ. Rotate the brake lever, on the backside of the motor, counter-clockwise (looking from the rear of the motor) about 1/8 of a turn to the released position. NOTE: If the RV has an underbelly or a cover over the motor, these parts must be removed to access the motor.Д¤. It will be mounted to one of the slideout rails.

For version 2, remove one of the motor leads, either the motor I or motor II lead from the controller.ДЈ. For version 1, unplug the (6) pin wiring harness from the controller. There are two versions of the controller. Locate the slideout electrical controller (refer to your dealer or RV manufacturer for location).

NOTE: The override will not work if the switch is turned on.Дў. Turn вЂњOFFвЂќ the on/off switch or key (if so equipped). ( We apologize for the fuzzy illustration.)ДЎ. Make sure the transit bars are removed (if so equipped).ДЄfter the previous items have been checked and the room still does not move when the slideout switch is pressed, follow these simple steps to manually override your slideout room.Make sure the battery is fully charged and connected.Make sure the slideout system is turned on.NOTE: If the room does not move when the switch is pressed, check the following: